This is a video that can be used to setup optical flow.
Optical flow that is use is like this.
Optical Flow V1.3
Until last progress 20/11/2023:
Do the work for 2 days.
Setup:
There will be a problem about the driver of the opt flow, when you connect the opt flow directly to the computer using USB Cable. Therefore, please make sure:
1) The opt flow is connected to the pixhawk flight controller to i2c.
2) Then power up the pixhawk normally using Lipo Battery.
3) The driver issue will be solved after 12v battery connected.
Result:
1) Images is detected by the Optical Flow ok.
2) Focus Image is ok.
3) Mounting to the drone is ok.
Problem:
1) Already test flight and cannot hover in place maintaining position.
2) The sonar is not showing any value, so i am using the lidar a that time, but the lidar seem to have problem, up and down, maybe the lidar were broken.
Info:
1) Height estimation need to be used before the pixhawk can be armed.
Documentation:
At this time, I only follow step 1.
Due to time constraint, didn't go to step 2.
No comments:
Post a Comment